Ceramic Band Heater Options

Available on most heaters with leads or post terminals. Some restrictions do apply, such as minimum size. Contact Thermal Corporation for more details.

Two-pole cup type European plug available on most configurations. Some restrictions do apply, such as minimum diameter and minimum width. Contact Thermal Corporation for more details.

Any reasonable size and location is available on custom designed heaters. Contact Thermal Corporation for assistance in determining feasibility.

May be added to most configurations.

Leads or terminals may be located at any reasonable place along the heater, for applications where standard connections may be inaccessible. Contact Thermal Corporation for more details.

A standard bayonet adapter is soldered to a bracket then attached to the heater above a 3/8" diameter hole. Please specify adapter length when ordering.

Stainless steel flexible hose soldered to elbow available on some configurations. Specify orientation of elbow to heater when ordering.

Stainless steel overbraid crimped to elbow available on some configurations. Specify orientation of elbow to heater when ordering.

Available for configurations with post terminals. Contact Thermal Corporation for more details.

Available on most heaters as a less expensive alternative to holes for thermocouple probe access. Some restrictions apply for heaters with mounting flanges. (Standard gap is 1/2"). Please specify "G" dimension when ordering.

Recommended for larger diameter applications (10" or greater) to ensure adequate clamping action.

Strain relief spring that goes over stainless steel overbraid (approximately 4” coverage from where leads exit heater). Available on Configurations 616, 617, 618, 619, 622, and 623.

Vented band heaters are used for high temperature heating and cooling extrusion processes.